Seedling Tolerance and Phasiological Response to Short-Term Soil of Three Eucalypts Species
Journal Article

The present paper involves a detailed comparison between the salt tolerance and physiological responseof three eucalypt species occurring within the Swan Coastal Plain, Western Australia. Eucalyptus gomphocephala DC (Myrtaceae) (common name ‘Tuart’) is restricted to the calcareous (limestone), brown or yellow sand of the coastal Spearwood dunes. Eucalyptus marginata Sm. (common name ‘Jarrah’) is a small tree on the porous, well-drained sandy soils of the Bassendean dunes Plain, and a much larger tree on the Darling Range. Corymbia calophylla (Lindl.) K.D. Hill & J. A. S. Johnson (common name ‘Marri’), and has a similar distribution to that of Jarrah, but is more common on wetter, well drained soils. This investigate implemented to find out the seedling tolerance of these three species to soil-induced stressor, namely salinity via addition of sodium chloride solution. Tolerance assessment measured changes in seedling growth, leaf allocation and leaf physiology after 70-80 days. Neither E. marginata and C. calophylla could tolerate the highest salinity (0.25 M NaCl solutions) with 9-13% survival, although E. marginata was clearly the least tolerant with 52% reduction in relative growth rate and a 88% in transpiration rates. E. gomphocephala was the most tolerant to salt stress in terms of survival and growth parameters. 

E. Farifr1 and S. Aboglila, (08-2014), SCIENCEDOMAIN international: British Journal of Applied Science & Technology, 4 (30), 4280-4290

Synthesis, Characterization, and Crystal Structure of [Co4(CH3CO2)2L4]2[BPh4]4⋅0.5H2O, Where HL = 4-(Salicylaldiminato)antipyrine
Journal Article

The title complex was isolated as a red solid from the reaction of 4-(salicylaldiminato)antipyrine, HL, and cobalt (II) acetate in ethanol. The complex has been characterized by elemental analysis, FTIR, UV-Vis, and X-ray single crystal diffraction. Two crystallographically different cationic units, A and B, of the title complex are found. Both units are essentially isostructural; nevertheless, small differences exist between them. Both units contain four cobalt atoms arranged at the corners of distorted cubane like core alternatively with phenoxy oxygen of the Schiff base. In both cases, one cobalt binds to three coordinated sites from the corresponding tridentate Schiff base ligand, and the fourth one was bonded by the acetate oxygen, and the fifth and the sixth donor sites come from the phenolate oxygen of another Schiff base ligand.

A. Eldewik, Ramadan M. El-mehdawi, Mufida M. Ben-Younes, Fathia A. Treish, 1 Ramadan G. Abuhmaiera, 1 Dejan Poleti, Jelena Rogan, (08-2014), Journal of Crystallography: Hindawi Publishing Corporation, 32767 (32767), 1-6

The Pseudo Relevance Feedback for Expanding Arabic Queries
Conference paper

Abstract With the explosive growth of the World Wide Web, Information Retrieval Systems (IRS) have recently become a focus of research. Query expansion is defined as the process of supplementing additional terms or phrases to the original query to improve the information retrieval performance. Arabic is highly inflectional and derivational language which makes the query expansion process a hard task. In this paper, the well known approach, Pseudo Relevance Feedback (PRF) is adopted to be applied on Arabic. Prior to applying PRF, first; datasets (three collections of Arabic documents) are pre-processed to create documents inverted index vocabularies, then, the normal indexing process is carried out. The PRF is applied to create a modified (expanded) query of the original one and the target collection is indexed once more. To judge the enhancement of retrieval process, the results of normal indexing and those of applying PRF are evaluated against each other using precision and recall measures. The results have shown that the PRF method has significantly enhanced the performance of the Arabic Information Retrieval (AIR) System. As the number of expansion terms increases up to a certain extent (35 terms), the performance has been improved. On the other hand, the performance will not be affected, or grow insignificantly as the number of expansion terms exceeds this limit. 

Abduelbaset Mustafa Alia Goweder, (12-2013), Poznan, Poland.: Proceedings of 6th Language and Technology Conference, (LTC), 359-365

CENTROID-BASED ARABIC CLASSIFIER
Conference paper

Abstract: Nowadays, enormous amounts of accessible textual information available on the Internet are phenomenal. Automatic text classification is considered an important application in natural language processing. It is the process of assigning a document to predefined categories based on its content. In this paper, the well-known Centroid-based technique developed for text classification is considered to be applied on Arabic text. Arabic language is highly inflectional and derivational which makes text processing a complex and challenging task. In the proposed work, the Centroid-based Algorithm is adopted and adapted to be applied to classify Arabic documents. The implemented algorithm is evaluated using a corpus containing a set of Arabic documents. The experimental results against a dataset of 1400 Arabic text documents covering seven distinct categories reveal that the adapted Centroid-based algorithm is applicable to classify Arabic documents. The performance criteria of the implemented Arabic classifier achieved roughly figures of 90.7%, 87.1%, 88.9%, 94.8%, and 5.2% of Micro-averaging recall, precision, F measure, accuracy, and error rates respectively.

Abduelbaset Mustafa Alia Goweder, (12-2013), Sudan University of Science and Technology, Khartoum, Sudan: Proceedings of ACIT 2013, 13-21

Arabic Text Categorization using Rocchio Model
Conference paper

Abstract— Automatic text categorization is considered an important application in natural language processing. It is the process of assigning a document to predefined categories based on its content. In this research, some well-known techniques developed for classifying English text are considered to be applied on Arabic. This work focuses on applying the well-known Rocchio (Centroid-based) technique on Arabic documents. This technique uses centroids to define good class boundaries. The centroid of a class c is computed as center of mass of its members. Arabic language is highly inflectional and derivational which makes text processing a complex task. In the proposed work, first Arabic text is preprocessed using tokenization and stemming techniques. Then, the Rocchio Algorithm is adopted and adapted to be applied to classify Arabic documents. The implemented algorithm is evaluated using a corpus containing a set of actual documents. The results show that the adapted Rocchio algorithm is applicable to categorize Arabic text. Ratios of 92.2%, 92.7%, and 92.1% of Micro-averaging recall, precision, and F-measure respectively are achieved, against a data set of 500 Arabic text documents covering five distinct categories.

Abduelbaset Mustafa Alia Goweder, (10-2013), Zurich, Switzerland: Proceedings of International Conference on Advances in Computing, Electronics and Communication (ACEC), 71-78

A Cross-Layer Decision for Mobile IP Handover
Journal Article

Network layer indications are not readily available upon a link change; therefore, general dependes on the network layer may introduce unnecessary delays due to network layer signaling for a simple link layer handover. If information could be gathered at link layer to determine the need for network layer signaling, then both the delay and signaling load could be really improved over the current standards of Mobile IP.

This paper presents a Cross-layer decision on two layer network and link layers to improve the performance of Enhanced Mobile IP (E-Mobile IP) handover in which reducing packet loss and latency during handover process.

Mohammed Alnaas, (08-2013), Lecture Notes on Software Engineering: international journal, 3 (1), 308-313

Crystal structure and magnetic properties of Y2(Cu1xMgx)2O5 obtained by SHS method
Journal Article

The single-phase polycrystalline samples of Y2(Cu1xMgx)2O5, x = 0.0, 0.05, 0.15 were successfully synthesized by a modified self-propagating high temperature synthesis. Effects of Mg+2 substitution for Cu+2 in

metamagnetic Y2Cu2O5 on its crystal structure and magnetic properties have been analyzed by X-ray

diffraction and magnetic measurements performed within 2–300 K range. Mg doping was found to introduce small distortions in the main intradimmer superexchange paths so that ferromagnetic correlations

decrease with Mg concentration. More significant impact of Cu substitution was found on the low

temperature magnetism due to the breaking of infinite Cu–O chains. The formation of finite size chains

introduces low temperature paramagnetic contribution and reduction in Néel temperature. Overall

results give a strong indication that the antiferromagnetic ordering as well as metamagnetism persists

up to the 15% of the Mg concentration.

Zohra Ali Mohamed Gebrel, Aboalqasim Alqat, (08-2013), The Vinca Institute, University of Belgrade: Journal of Alloys and Compounds, 582 (2014), 186-189

Organic Geochemical Evaluation of Cretaceous Potential Source Rocks, East Sirte Basin, Libya
Journal Article

Cutting samples (n = 93) from the Sirte, Tagrifet, Rakb, Rachmat, Bahi Formations of Upper Cretaceous and Nubian Formation (Lower Cretaceous) derived from eleven wells (6C1-59, 6J1-59, 6R1-59, KK1-65, OO2-65, M1-51, KK1-65, B-96, B-95, B-99, E1-NC-59) locate in the Amal, Gialo, Nafoora, and Sarir Fields present in East Sirte Basin were analysed in the aim of their organic geochemical evaluation. A bulk geochemical parameters and evaluation of specific biomarkers by chromatography-mass spectrometry (GC-MS) implemented to find out a diversity of interbedded non-marine lithofacies including sandstones, siltstones, shales and conglomerates. Such rocks are good source and contain fair to good contented of organic matter passing in the course of very good, in which the excellent source rocks have organic carbon richness (TOC) reached to 5.16 wt%. The studied samples are ranged from gas to oil-prone organic matter (OM) of hydrogen index (HI) ranged between 115 - 702 mg HC/g TOC, related with gas prone (OM) of (HI) <150 and most beds contain oil-prone organic matter of (HI) > 300, associated with oxygen index (OI): 3 - 309 mg CO2/g TOC indicate that organic matter is dominated by Type II/III kerogen. The maturity of these source rocks is variations ranges from mature to post-mature-oil window in the Sirte and Rachmat Formations, as inferred from the production index (PI: 0.07 - 1.55) and Tmax and Ro% data (Tmax: 425 - 440/Ro%: 0.46 - 1.38) and early to mid-stage maturities for the other formations. Low PI in some samples seems to imply that the most of the hydrocarbons have expelled and migrated from the rocks. Biomarker ratios of individual hydrocarbons in rock extracts (n = 21), were also used in order to investigate the samples’ thermal maturity and palaeo depositional conditions. Pristine/Phytane ratios of 0.65 - 1.25 and dibenzothiophene to phenanthrene (DBT/P) ratios of 0.04 - 0.47 indicated Anoxic and suboxic conditions of depositional source rock. The origin of OM of the studied samples attributed to a marine algal source as indicated from the dominated by the C27 and co-dominant C28 homologues sterane in molecular composition distributions. The marine shale and carbonate lithofacies of rock samples were also indicated by high C19TT/C23TT ratio and low relative abundance of C24TeT/C23TT, consistent with their interpreted marine affinity. An organic geochemical evaluation pointed out that the Sirte Shale formation (Campanian/Turonian) is the main source rock in this petroleum area. 

S. Aboglila*, , M. Elkhalgi, (06-2013), scientific research: International Journal of Geosciences, 4 (1), 700-710

Specific Biomarkers to Determine Geochemical Characteristics of Oils from the East Sirt Basin, Libya
Journal Article

Tricyclic terpanes to hopanes Ratios calculated from individual biomarkers to delineate their distribution, identifications, mixing ratios and biological precursor in a suite of crude oils (n = 24) from the East Sirt Basin. Geochemical application of Tricyclic terpane and Hopane biomarkers is divided studied oils into five groups (I, II, III, IV and V) based on the different ratios between Tricyclic terpanes to hopanes. Percentages of C23 Tricyclic terpanes/17α (H), 21β(H)-hopanes (C30αβ) and C28 Tricyclic terpane/17α (H), 21β (H)-30 hopanes (C31) have divided crude oils into 2 main individual groups in addition to 3 mixed groups. Group I, characterized by the dominance and extension of the tricycle terpane series (≈ C45 Tricyclic terpane). Group V, distinguished with the dominance of 17α (H), 21β (H) hopanes series. Groups II, contained a domination Tricyclic terpanes and hopanes, considered as a mixed group. The group III demonstrated equivalent ratios of Tricyclic terpanes to hopanes. The Group IV revealed a reduced amount of Tricyclic terpanes with enrich of hopanes. Tricyclic terpanes derived from tricyclohexaprenol precursors and attributed to a marine depositional environment and algal matter. Hopanes in obtained from bacteriohopane polyols and aminopolyols and distinguished to a depositional bacterial environment.

Salem Aboglila, (06-2013), Azzaytuna university: Azzaytuna university Journal, 7 (2), 37-47

Combustion synthesis as a novel approach in preparation of polycrystalline Y2Cu2O5
Journal Article

Polycrystalline samples of Y2Cu2O5 were for the first time sintered from precursors obtained by two combustion routes – the glycine–nitrate method (sample S1) and a modified self-propagating high-temperature synthesis (sample S2). The detailed X-ray diffraction analysis has confirmed that both samples are

well crystallized and single phase, with the high crystallization degree and cation ordering within a Cu

sublattice. Magnetic characterization has shown magnetic behavior typical of pure Y2Cu2O5. The distinctive advantages of these new synthesis routes in comparison to the ceramic sintering are in simplification

of the overall proce dure as well as in a significant reduction of synthesis duration from several days down

to 31 h (S1) or 12 h (S2).

Zohra Ali Mohamed Gebrel, Aboalqasim Alqat, (03-2013), The Vinca Institute, University of Belgrade: Journal of Alloys and Compound s, 568 (2013), 55-59